I am also a little concerned about the thin canopy. Might have to laysome FG in it.
I am also a little concerned about the thin canopy. Might have to laysome FG in it.
What the heck is the canopy made of anyway?
Looks like Lexan.
Nortavlag Bulc
what kinda crazy tumbleing crash did u do to break that canopy in two? wow.......do u think a couple of fiberglass strips will do it ?
MY RETIREMENT PLAN?????.....POWERBALL
74 vintage kirby clasic hydro, pursuit mono, mg, 47'' mono, popeye hydro...
Cracked mine already. Not as bad as Steven, but it cracked. I scratched the inside of the plastic up and put down some thin FG then resin'd over it. The factory canopy is weaker than puppy piss.
FE BOATING: Less like a hobby and more like an addiction!
I'm not sure the material. Same stuff the sub-hatch is made out of. Mine appears to have started cracking up near the front where the pin is. I think I may pull that pin off and just use some small pieces of tape front and back to make sure it says on.
Material is great for casting in scale details, and great for racing (light weight)... perhaps not so good when you crash... Luckily, replacements aren't very expensive.
Darin E. Jordan - Renton, WA
"Self-proclaimed skill-less leader in the hobby."
$17.99 in stock, not to bad. maybee this is the oportunity for someone to make a fiberglass or thicker abs one????
see my fleet : https://forums.offshoreelectrics.com/...hp?albumid=294
Bookmarks