see the space in the dog drice i think they left to wide of a gap?
anyone with these boats is this how they come as mine is new never run i just think they installed the dog unit on wrong?
THANKS
see the space in the dog drice i think they left to wide of a gap?
anyone with these boats is this how they come as mine is new never run i just think they installed the dog unit on wrong?
THANKS
I would say thats the gap left to account for the flex cable shrinkage when the boats running. I wouldn't worry.
Grand River Marine Modellers
https://www.facebook.com/search/top/...ne%20modellers
it is not a flex cable, shaft drive.
I has not been installed wrong, just slightly loose.
if you want to close that gap all you have to do is loosen the set screw on the universal, close the gap, and re tighten. leave some play though, so the drive system doesn't bind.
Thats what I thought till I saw the universal joint, you cant see what's on the other side of it but i would guess a UJ on the end of a flex would whip like crazy and its a solid shaft, if that is the case the likelyhood is they leave the gap in case the UJ isn't exactly lined up with the pivot for the leg, move the leg full left to full tight and see if the leg slides further out on the stub shaft at any point in the travel, if not feel free to undo the grub screw on the dog drive and move it a bit further in.
Thanks for the info Guy's will take a look at it later.
THANKS
It looks the same as whats on a black jack 26.
mine was always up close to the strut, I figured thats why theres that nylon washer on it,
so it does'ent bind, sort of like a thrust washer.
but then again the u-joint is not that strong and could fail under load.
most bj owners replace the hardware with somthing else, speedmaster ect...
Check out off shore electrics site. also graves hobby in orlando fl.
Bookmarks