I am having a problem trying to charge my 2s 5000mah turnigy lipo battery on my hyperion duo3 charger. It all started when I was bashing with my savage flux that the whole thing just stopped working then when I checked the battery connections one of the black wire was loose. So back home I re-soldered the deans connector & when I plugged it into the charger it would read an error msg: "output battery connect error" so I cleaned the female connector with a small screwdriver & rubbing alcohol & when I plugged it back in it would say: "balance voltage cell 1 too high". So I looked @ the balancer screen & cell 1 was reading @ 4.5v & cell 2 was @ 3.8v so I tried doing a balance charge but a few seconds later it would start beeping again saying "output battery connect error" on the screen. Now I want to know if there is something wrong with the connector of my battery or is the battery possibly damaged? The battery itself is not puffed or anything I just want to know why it's doing this & is there any possible way you can help me get my battery going again?
Bookmarks