I just orderd my wire and bullets from OSE and got the 10 gauge wire with 6mm gold bullets. I also had an amazon gift card to use and found some thunderpower 3s 5400 25c hard case packs, so i ordered 2 of them. These will be my main boat packs. I'm wondering about just taking off the deans plugs and soldering on the 6mm bullets? Good idea right? Or not? I ordered 18 pairs of bullets and was gonna do all the connections with them (should have a couple spares).
Also, if the packs have 6mm bullets, could I make a short traxxas plug to 6mm bullet 1" or so wire to run these in my slash or slash 4x4? The 6mm bullets should cause no resistance bottle-neck or any other probs there right? I was going to do 12 ga wire, but I'm mounting my ESC pretty far from the batts and wanted less resistance...???
Bookmarks