Just went out for some runs with the fullers hardware. The water was crystal clear so i was hoping for good runs.
At 4s the boat looked good, and where stable even with WOT doing around 30Mph.
But when changing to 5S i encountered some problems.
First of i am not able to hit full trottle right away, when giving full trottle the prop starts spinning for about a sec and then stops, i have to gently press the trottle and then slowly start building revs. This problem happend after changing to the fullers hardware. Workes like a sharm on 4s but not 5s.
Also when passing 40Mph the boat starts to get realy unstable. Before changing to the fullers i where getting good and stable runs at 45Mph, but not anymore.
It looks like the right side is sticking lower into the water than the left, even when having slightly heavier lipos on the left (added some lead to the 2S packs so they are about 60grams lighter than the 3s) I might think that the rudder may couse the boat to be unstable. The rudder is a bit loose so might be the problem, any other ideas?
Bookmarks