Hello all
New to rc boating
Question is. What Dasboata prop to use on 6s
17/16 or 18/15 for speed. TIa
Printable View
Hello all
New to rc boating
Question is. What Dasboata prop to use on 6s
17/16 or 18/15 for speed. TIa
all of the above !!
Thanks for the reply Chris. Do you make or sell a conical type prop nut for this setup. Trying to get all I can out of the lower end. TiaQuote:
Originally Posted by dasboata
I do 3 for $10 comes with the lock nut made out of all aluminium
ok cool. Do you have pics on your site. I can seem to get the thumbnails to work on this Mobil site.
Thanks Chris
Quote:
Originally Posted by Mr Zelos
Yes, correct I have logged over 95mph with both of those props on my boat. I know another person who has hit 95mph running a Geico 36 with Chris' 1716's as well. Great choice right there.Quote:
Originally Posted by dasboata
Mine has ran 90 - 92 with a 1716. Still playing with the trim. I can run 83 - 85 for 4 minutes not running wide open all the time. Dasboata props make a DIFFERENCE!!!
Thanks for the reply. What type of prop nut did you use? And trim and strut adjustments. Positive/Negative degrees. Also weight displacement. Fore or aft. Still learning. Thanks for your help.Quote:
Originally Posted by MADRCER
You'll just have to play with the struts until you get them right for your conditions because what works for me sometimes don't work for others. Strut setting depends on what water conditions, what props are on the boat, and if one is running 2 or 4 batteries. I have been running the stock prop nuts on this boat. I normally run these nuts on my other boats. https://www.offshoreelectrics.com/pr...od=ose-zn-8135Quote:
Originally Posted by Mr Zelos
Nice speeds!Quote:
Originally Posted by EddieM41
Thank you for accepting me into this forum!
I am looking to Upgrade my miss Geico twin 36" to some ABC-Dasboata props, but upong going to dasboata website I do not find the props ABC1716 pair or ABC 1815 pair everyone is raving about. I do not have Facebook or other Social Media. I follow MrMad2424 on youtube and I am trying to get some speed like his boat.
Ant help and guidance in prop selection would be greatly appreciated. I just want to buy a few sets of props to mess around with SAW and Moderate Lap running to have "options" besides factory props. I have full factory ESC's and Motors so I do not want to blow those things up (just yet). Thank you!
You can email Chris (dasboata) at dasboata@aol.com or pm him on here by clicking his Avatar is in post#4 aboveQuote:
Originally Posted by Screamin Creedmoor
thanks Mark Did I answer you ?Quote:
Originally Posted by Screamin Creedmoor
Yes sir...replied and purchased your set 4/28/2020. Thank you very much! Look forward to running my virgin boat on your props!
Received the Dasbota Octura x447 B&S and I can attest that this prop has planted my Miss Geico onto the water. Ran my boat on slightly ripped water on 2-3S packs and got 57mph. Boat was hugging the water and a little wet, but could never get the factory 1716 copies to hold the boat on the water. Thank you Chris for these props!
Purchased Dashobota's 1716's for my twin Zonda last year (for a race against a cat with a weedwacker engine that never happened (he passed away)) and have been averaging the mid 90's.
Just watched Madracer's vid on his Zonda (100mph stock without dashpota's props) have no clue how to catch him on that (he's my hero).
loosen the boat up by raising the angle of the drives your scrubbing alot of MPHQuote:
Originally Posted by Screamin Creedmoor
Will defiantly raise the angle of the drives. We have a lot of wind down here in Cypress, Tx. Have to find a lake long enough to run with a tail wind..