Kintec flex shaft does not fit in my MG

Im lost! Twisted the original flex on my MG, probably due to my newly added Leo 4082 2200kv, anyway, got the flex out and ordered a new from kintec. The other day i was trying to change but no succes. Didnt go in. Then i noticed something looking like a spring, dont know if its somekinda tube for the original flex or was it a piece of the old flex. Got it out with a few pieces of teflon tube. The new flex is going in but not the teflon tube which came with the new flex from kintec. My question is: should the new teflon tube go in, or do i just have to forget the teflon tube a put the flex staight in? . Could it be that the old teflon tube is stocked inside?

Best regard from jacob

You may need to stretch the new Teflon tube a bit to get it to fit in the stuffing tube. once in let it set for a bit and it will go back into shape. Had to do it with one I got from Kintec for my sv27.

if its the upgrade shaft its a bigger cable and should have come with a new teflon liner to be put in with the new cable

Thx :)

Quote:

---

Originally Posted by MAMBA2200

if its the upgrade shaft its a bigger cable and should have come with a new teflon liner to be put in with the new cable

---

Hello MAMBA just wanna ask what is the pitch thread of MG 29 stock flexshaft,,tnx

Quote:

---

Originally Posted by Muckhangbata87

Hello MAMBA just wanna ask what is the pitch thread of MG 29 stock flexshaft,,tnx

---

He had not been on the forum for quite some time.
All thread pitch we use for 3/16" shaft is 10-32.

Old old thread but is there a better way? Have the same issue with OSE Version 1 cable.