One recommendation is ABC 2216-3 CR which i am trying to get, and thanks.
Printable View
One recommendation is ABC 2216-3 CR which i am trying to get, and thanks.
That sure looks like alot of motor for those little esc's
Attachment 159328Quote:
Originally Posted by dmitry100
I have pulled 380 amps out of them in a car, software is set up at 398 amps to cut out, isent that enough?
I think 2 blade props would be more suited for SAW.
Yes 2 blade for saw and 3 for oval. I would go for 2218 or 2219 2 blade if your going for max speed.
Mark
Thanks :tiphat:Quote:
Originally Posted by rol243
Thanks mark will have a look at them .:beerchug:Quote:
Originally Posted by MarkF
Look what arrived today :banana:
Attachment 159330
Just placed the ESC in there to see if the hatch shuts :biggrin:
Attachment 159331
Attachment 159332
What to do first :biggrin:
Very nice. Should be a rocket when your all done.
Mark
Yes thats a very nice looking hull.
It will be :laugh:Quote:
Originally Posted by MarkF
Very sharp lines, like a knife , the one thing i did not like is the motor mount it is only 3mm should be 6mm, need to support the rear of the motor now :thumbdown:Quote:
Originally Posted by rol243
My son purchased an additional pair of mounts from MHZ for his 114 so will laminate two mounts together to give him the required thickness.Quote:
Originally Posted by Speedfreek
Wahoo, there is gonna be some speed on here this year.
Yea that's what i am thinking go thicker there and not worry about rear support mount.Quote:
Originally Posted by Old School
I hope so :tongue_smilie:Quote:
Originally Posted by srislash