http://www.offshoreelectrics.com/ima...op_diagram.jpg
Printable View
Broken tip on the left side?
I used a new prop, so it wasn't broke. I think it's the way I took the photo.
Great explanation and picture Steve need to be in a Read this first Newbe and yes for everyone.
Steven,
Here is a copy of the latest Octura information sheet 9.2012 listing the Prop number, Diameter and then Pitch.
Makes it easier for me to follow and then make a decision on which ones to order.
Mike
can you email it to me or try to attach it again?
Attachment 86032
Here you go Steven
Trying to find where to buy a b/s x440/3 I think it is a stainless steel for my Miss Geico 29 v3 all stock
I just sent you a pm.
I just received two Octura X440/3 props and both of them seem to have the same problem, they will not fit the drive dog.
it seems that one side of the slotted end of the prop is misaligned and if I removed about 1/16" from one side on the leading edge it would fit, but would be out of balance. what would you recommend.
Yep use the little doggy.
Removing material from the hub has less of an effect on practical balance than you may think. Removing 1/16" from the slot sounds like way too much however...
.
The drive dog slots are fine the tongue material is covering the the drive dog slot on one only
Attachment 149347Attachment 149348Attachment 149349
Hope you can see this.