Hifei Swordfish 240 amp

HI

I have a Hifei Swordfish 240 amp conneted to a Leopard 5692 Motor

I put everything in receier and batteries and the esc turn on but does not work?

http://s1218.photobucket.com/albums/dd412/Jr_Jose1/And idea?

http://s1218.photobucket.com/albums/dd412/Jr_Jose1/

[IMG]http://i1218.photobucket.com/albums/...1/IMG_0021.jpg[/IMG]


Thanks

Are you able to program iit?

calibrate the throttle

may need to rev throttle channel also(futaba)

also youll need a reciver pack for that esc

Quote:

---

Originally Posted by Alexgar

may need to rev throttle channel also(futaba)

---

Yes it a futaba)


and the its does have batteries on the esc and the receiver

rev the throttle channel and try and calibrate it does it make any noise when you plug it in

here are the instructions if you dont have them
http://www.astecmodels.co.uk/pdfs/Sw...200A%20ESC.pdf

See 112 and 115 https://forums.offshoreelectrics.com/...aba#post179370

the only way I have been able to calibrate it is with it full throttle and then full reverse to stop , I would like to only have to use the throttle ??

Thanks

got it to work , but the Esc should not turn red at full throttle should it??

what should the Pwm 8khz or 12 , or 16 ?? in the program?


Thanks

i have the 120 and i never even noticed an led

leds on are on the bottom if esc , what i like to know if how to tell if the motor is reaching top rpm correctly? 5692 I have make a very quiet

Thanks

Your short shrunk leads off the ESC motor end are scarin the heck out of me. Please insulate your connectors before the fire works go off.