Printable View
It connected no problem and was programmed. I then checked out the data logging and it worked fine but then after the next run it refuses to connect again. I tried running as administrator and also deleting and reinstalling the software (6.0 or 6.1) without any luck. Anyone else have this happen to them? https://uploads.tapatalk-cdn.com/201...68f66b4a73.jpg
Sent from my SM-N950U using Tapatalk
I've had the same, turned out to be a wire in the USB connector that was not connected to the board. Only found it because the plastic cover was so loose.
Well I will have to open it up and take a look, hopefully its that easy considering that is the only way to program the ESC.
Didn't have to open it after all, purchased a new cable and it works like a charm again.
Sent from my SM-N950U using Tapatalk
Well that's good news :thumbup1: