Just poking around. Helping someone else with an issue.I was just bugging Ray,I did the CF.
I had thoughts about painting Jason's MG but I have to work tomorrow and if I start...
Printable View
Just poking around. Helping someone else with an issue.I was just bugging Ray,I did the CF.
I had thoughts about painting Jason's MG but I have to work tomorrow and if I start...
Theres one here in Aussie to, bought it from Scott in 07, sold it in 11. Big mistake, definitely my favourite boat, was a missile with 1515 1y 4s1p and a mod m445 prop.
http://youtu.be/Xr1frWqlRpE
I got a pair of Etti drives from you along with two counter-props, were these used with this boat? I am thinking of a H&M Intruder S twin build and have a question regarding your opinion on the .130 cable and 4mm shaft that was on that set. Are they good to handle FC 3216 Outrunner (2200kv on 4s) ?
I sent the hull for CF lay up, I think it is 30" or there about.
Attachment 125191The smaller one... 750mm length.
Thanks in advance!
I think you will be good, the skunk was 32 inches.
I know this is an old thread, if you gents are still around, is this a Skunkworks gen 2?Attachment 167245
I hate to revive an old thread but haven't found much info on this boat. Is this one of the original skunkworks?
Attachment 168220