new Turnigy 120amp 180 amp esc

[bustitup]

Anyone seen this or is it just new to me?

https://unitedhobbies.com/UNITEDHOBBIES/store/uh_viewItem.asp?idProduct=8921

[Flying Scotsman]

The Turnigy ESCS are very good value but they are large. I do not water cool the ones I have as their size does not warrant it. I am talking about the HV and high amperage units. They may not fit in small boats and get enough air cooling. Also all of mine needed (3) required a Pistix to function, that may have changed today

Douggie

[bustitup]

The Turnigy ESCS are very good value but they are large. I do not water cool the ones I have as their size does not warrant it. I am talking about the HV and high amperage units. They may not fit in small boats and get enough air cooling.

Douggie

What I meant was this looks like a new upgrade of the popular Turnigy 100amp hv
that is so used in FE and it will run on 12s

do you a run fan on yours Douggie?...how big a boat do you run them in

[Flying Scotsman]

No to the fan. a 32" mono, a 34" cat and a 29" mono and all are HV ESCS

Douggie

[j.m.]

http://www.hobbycity.com/hobbycity/store/uh_viewItem.asp?idProduct=8937&Product_Name=Turnigy_Marine_180A_Brushless_Boat_ESC

[6S HYDRO]

So douggie, your not cooling them at all. They dont get hot?

[Flying Scotsman]

So douggie, your not cooling them at all. They dont get hot?

Nope, the heat sink is huge. This is for the 100amp HV esc. I can not speak for the new series.

Douggie

[Punisher 67]

I built a test stand to load test my motors and lipo's with a Seaking 180 , here is some video for what its worth

http://www.youtube.com/watch?v=KmX2NABdHFM

[jcald2000]

Nice Job as usual!
Camara need to be closer to screen, can't read data headers.

[Punisher 67]

Sorry about that I will re-do this video but need to buy a smaller prop for load , a 10/6 is to much for this motor and I don't want to smoke another high power high end unit

[jcald2000]

I run an 8x4 on big motors and 7x3 on 4s motors.

[LiPo Power]

This ESC looks good to me for the buck.... How would this compare to Castle ESC?

[bustitup]

I cant get my turnigy 180amp to give me full voltage.....I hope its my fault..hate to think I got a bad one

[Punisher 67]

Nick Can you post what your setup is and settings on the ESC , I find if I have the 3.4 volt cutoff even fully charged batteries hit the limiter very quickly and will not give full power on the test stand , maybe 30 seconds and thats it , 3.2v is what I set the cutoff at under load

I am sure it can easily hold its own against one , at least you don't void your warranty if you run 6S

[bustitup]

Peter
Its my mean machine cat
I used the optional programer set at
Forward only
Low start
LVC at 3.2 per cell
Low timing

Flight power 2s 5000mah 25c x2 in series
2200kv castle neu motor

Boat would only go 23mph......soon as I switched out the esc she ran 43mph

Using a m445 prop