26” Vac-U-Pickle with 2S/4S motor combo

[longballlumber]

Hey guys,

I have a Pickle that I will not be running anymore. I raced this boat at the Nats this summer and did pretty good considering I was running a much older 2 pole motor. This boat will run mid 40’s using the Hacker 8S that is currently in the boat. I would also be willing to bet you could squeeze 50 out of it with the Hacker 9XL that is included. But of course mileage will vary.

Before the nats I put a paint job on it. Unfortunately, it didn’t escape without a couple of dings from racing. They are towards the rear of the hull.

All included below…
Vac-U-Pickle hull w/hardware installed (Original new Decals included)
Fullers strut and bracket
Speedmaster Mini Rudder Assy
Kintec HD turn fin bracket with GrimRacer fin installed
Several extra turn fins
3 different Hughey flex shafts (2X .150 and 1X .130 I think) Also 2X are 3/16” stub the other is 1/8” stub
Hacker 8S (with cooling jacket) – Motor hasn’t been run since a new rotor and bearings installed by Hacker
Hacker 9XL (NO cooling jacket) – Motor hasn’t been run since a new rotor and bearings installed by Hacker
Feiago 6L (with cooling jacket) – used
Has a Hitec 225MG steering servo

Price is $200 and the buyer pays for the ride of his/her choice.

[nitronuts]

any chance of 200 shipped to 14617

[longballlumber]

How about $210 shipped? I will eat any shipping costs over the extra $10 bucks?

Later,
Mike

[nitronuts]

Payment Sent/Thanks Joe

[longballlumber]

Got it, we are good to go. I will get it out on Monday.

Thanks
Mike