Tweet
I really had to think twice about this one but I have too many irons in the fire and need to fund a couple projects already in the works. I'm putting up for sale my 37" FighterCat Shocker. This boat has been over 100mph when I had it set up for SAWs which actually resulted in improvements being done to the hull. During the course of getting it dialed in for SAWs I found the factory joining of top and bottom left much to be desired. The hull now has carbon fiber reinforcing inside along the seam lines combined with a special high end 2 part foam filler in the front of the hull and sponson tips which greatly increased it's strength and toughness. The bottom ride surfaces have been fully prepped and trued up. The custom full wrap was applied by "Mono Jeff" Ross and when I sent it to him I only gave base colors, he was given full "artistic liberty" and sent back the really trick wrap you see here. It is tough as nails and has no issues with the taping down of the cowl. The rear hardware is Speedmaster, the carbon fiber motor mount from FC. The motor is a NEU 1521 1Y, the steering servo is a Futaba 3050 digital hi torque. All one needs to add are a prop, RX, ESC and packs to be water ready. This boat can be run 4S to 6S but if you've got the stones drop 10S in and head for SAWs. This boat on 10S with a 50mm prop will go over 100 and has done so in that configuration multiple times. I would prefer to sell boat as a package, $650 plus packing/shipping owns it.
Nortavlag Bulc 
Comment