FOR SALE 37" Carbon Fiber Fightercat Daytona #071

[jj2003]

Up for sale is my 37" Fightercat Daytona #071 in Carbon Fiber. Setup as a twin engine. Comes with two FC 3730 T600 Class 1600kv out-runners. Water cooled motor mounts. Two twin water pick ups on the bottom of the hull. 3/16 stingers. 115mm V-mount rudder(spare) 115mm extended rudder(mounted). Two 3/16 wire drive's with drive dogs and 3/16 tapered prop nuts. Also four 3/16 square drive prop shaft's for flex cable's (flex cables not provided). Custom LED lighted hull (see pics and video) Side mounted LED lights operate off of a 12volt #23a flashlight battery( battery holder is included). The LED running lights operate off of a rx on channel 3. Needs to be cleared. All decals except the ones on the hatch have been sealed in clear epoxy. Hull has been water sanded with 1500 grit paper. All LED inserts will be included and I would recommend they be installed before clear coating to seal them in. SOLD, CONT. U.S. ONLY. I accept paypal. Ask any questions on the thread to avoid any issue's.

Build thread

http://forums.offshoreelectrics.com/...0-s&highlight=

picture thread

http://forums.offshoreelectrics.com/...hp?albumid=700

Video's

http://youtu.be/yLkQNEykdxI

http://youtu.be/eRJqW3cIwNM

[jj2003]

Now $400 shipped

[jj2003]

More pics


[ATTACH=CONFIG]106631[/ATTACH][ATTACH=CONFIG]106632[/ATTACH][ATTACH=CONFIG]106633[/ATTACH][ATTACH=CONFIG]106634[/ATTACH][ATTACH=CONFIG]106635[/ATTACH]

[jj2003]

a few more


GEDC0478.jpgGEDC0479.jpgGEDC0480.jpg

[jj2003]

1 week bump

[Fella1340]

Hello there, I am.wondering about the leds on the sides of the boat. What size holes have been drilled in the hull to accommodate them?

[jj2003]

They are 3/4 in. to accommodate waterproof LED's used externally in automotive application's. They are powered by a 12volt clock battery that includes a holder for the battery.

[jj2003]

Weekly Bump

[jj2003]

Weekly bump

[jj2003]

Still for sale

[78MaicoRider]

What props are you running and what top speed? Motors running cool?

[jj2003]

At the time, I had Octura 447 L & R. I was never quite able to reach top speed due to lake conditions(lake Erie is just a bit rough) but at one point I hit 48mph before I hit a wave and flipped her. My Contour camera recorded both speeds and GPS tracking and it's in one of my video's. I now have a pair of FC CNC aluminum 5518's (I think thats what they were, I can't find the packaging right now, but once again never got to run her due to not being able to complete her. The props will come with the sale but she currently has no ESC's( originally they were T-180's) but I parted them out some time ago.

[jj2003]

weekly bump

[jj2003]

weekly bump

[betalkin]

is it ARTR?