Tweet
Due to financial constraints, my dream boat has to go.
SSSOOLLLLDDD $950 shipped cont US. requires rx and batteries. All offers posted in this thread (please no low balling)
- Aeromarine xXx (all red) hull bought new from Remy, blueprinted with lots of sanding and bondo; painted in primer and sealed with clear overcoat = very true!
- Fiberglass reinforced seam (inside) from bow to stern (it busted open and was repaired even stronger!),
US Composites 2lb foam in bow = very strong
- Shoebox filled in with bondo (outside) in the areas painted white = very cool (one of a kind)
- Krylon paints (all except red - that's the fiberglass and it looks real nice in the sun; and orange - rustoleum with metalflake topcoat)
and reflective orange trim tape on bow.
- Main graphics were custom designed (by me) from doityourselflettering.com in Premium 3M™ Cast Vinyl,
rest of graphics printed on clear adhesive vinyl ($60 worth!). no clearcoat was applied on top of the graphics
(i.e., they can be removed without any damage to the finish.
- Castle 2032 motor bought new from OSE July 2011, well maintained, routinely oiled bearings with nano-oil
- Castle HV 200 bought new from Tower hobbies with 50V caps added, 8mm bullets with splitters to take 10S2P with 5.5mm bullets
- New HiTech 1/4 scale servo with carbon reinforced push rod
- Speedmaster hardware with flooded stuffing tube to allow for up to 1/2" adjustment, .25" flex with drive dog attached to the 1/4" stub
for added strength (I learned the hard way)
- Octura 462 detounged and balanced by me.
Here's a vid before graphics. this clip was right about 60 mph.
SSSOOLLLLDDD $950 shipped cont US. requires rx and batteries. All offers posted in this thread (please no low balling)
- Aeromarine xXx (all red) hull bought new from Remy, blueprinted with lots of sanding and bondo; painted in primer and sealed with clear overcoat = very true!
- Fiberglass reinforced seam (inside) from bow to stern (it busted open and was repaired even stronger!),
US Composites 2lb foam in bow = very strong
- Shoebox filled in with bondo (outside) in the areas painted white = very cool (one of a kind)
- Krylon paints (all except red - that's the fiberglass and it looks real nice in the sun; and orange - rustoleum with metalflake topcoat)
and reflective orange trim tape on bow.
- Main graphics were custom designed (by me) from doityourselflettering.com in Premium 3M™ Cast Vinyl,
rest of graphics printed on clear adhesive vinyl ($60 worth!). no clearcoat was applied on top of the graphics
(i.e., they can be removed without any damage to the finish.
- Castle 2032 motor bought new from OSE July 2011, well maintained, routinely oiled bearings with nano-oil
- Castle HV 200 bought new from Tower hobbies with 50V caps added, 8mm bullets with splitters to take 10S2P with 5.5mm bullets
- New HiTech 1/4 scale servo with carbon reinforced push rod
- Speedmaster hardware with flooded stuffing tube to allow for up to 1/2" adjustment, .25" flex with drive dog attached to the 1/4" stub
for added strength (I learned the hard way)
- Octura 462 detounged and balanced by me.
Here's a vid before graphics. this clip was right about 60 mph.
Comment