WTS: 0.150, 0.167, 0.078 couplers. Turnigy T600 outrunners and 4082 leopard

[siberianhusky]

Nice new post about you in the bad trader section, enjoy!

[battlefury]

I dont no about all that, but for me im going to hange on and keep saving to finish my twin cat build,, i keep pushing it back,,thanks anyway bro..

to be honest with you these motor are alittle huge for 37" cat if you are going twins. have fun buliding!

[battlefury]

This guy is a scammer guys, you heard it he knew those collets didn't fit yet he still sold them to people! And he will not come good for selling a product he knew wouldn't work!
I'm not going to follow that mass of gibberish he posted as a repair! I can see an out of round or off center hole happening, at 30 000 rpm that will vibrate.
I'll be reporting you in the bad trader section. I hope this is the end of your ripping people off!

Husky would you just get off my back and leave me alone? The fact that you just given a whole new meaning of being stubborn and sore, i made my stand very clear if you want one i can replace one for you with shipping bear half by you. take it or leave it
If my intentions are rip people off, why do it for a few bucks? and put everything on the line. having said that It was never my intentions
Put it this way, like you i am a victim of your so called being 'ripped off' from the vendor. (For the record, i am a end-user not a retailer or whatsoever) However i chose to move on and get it rectify to fit instead whinning and bitching like somebody.

IMO, it does fit.

SAM_0141.JPGSAM_0146.JPGSAM_0147.JPGSAM_0148.JPGSAM_0151.JPG

[siberianhusky]

Lets see here, a bent wire that I have to pay part of the shipping for YOU to replace, and drill out a brand new coupler because you will not replace parts that you admitted above have problems!
That sir is the definition of a scam! you take peoples money and give them junk in return then refuse to make full amends when people complain. I don't care if you are a retailer of an end user, the fact is you KNEW the collet wouldn't work and sold it to me anyway.
You want me off your back, simply return my money and I'll gladly tell people you came good on the parts in the bad trader thread.
Simple, the balls in your court, play however you want.
I'm glad something you have probably modified fits for you, fact is mine does not and I want my money back! Just like any other time I buy something that is no good.
But I guess I'm just dealing with a garden variety crook here.
20$ here 20$ there all adds up.
Post anything for sale and I'll post a link to this thread unless you do the right thing and come good for the faulty parts you knowingly sold me.
Easy for you to make this right
my paypal is [email protected]
Entirely up to you what you want to do.
Sorry everybody but you can see what kind of vendor this guy is! Admits there is problems with yet leaves me hangin! If he had been honest and told people these collets need work fine, but he didn't!

[battlefury]

hmm.. alrighty since you want it this way. PP is on your way back. Sorry everybody for any inconvenience caused

[LarrysDrifter]

Those China collets aren't worth a damn. I had one and had to drill the motor side out to fit the shaft. The flex side is horrible too. I lost an entire drivetrain because the collet wouldn't tighten down enough even though it felt like it did.