2013 NAMBA SAW Time-Trial - November 8th, 9th & 10th at Legg Lake!

[urbs00007]

tyler, questions if you dont mind . what props are breaking on you? or at least what diameter ? are they too hard? how many rpm's are you turning and what drive system is faster, wire or cable in a S or T rigger? thanks

[RaceMechaniX]

I was breaking Octura and ABC props. They were all hardened to what we thought were good levels of compromise between stiffness and ductility. Props ranged from 42mm to 50mm. The wire drive has more advantages for my setup, but I ran several fast passes with a flex cable as well. It all comes down to how you set it up. The RPM was very high, I will just leave it at that.

Tyler

[urbs00007]

when you run neu 1527 at high rpm in rigger saw do you need 8mm shaft or will the 5mm suffice?

[RaceMechaniX]

Definitely 8mm on the 1527 at high speeds.

[RandyatBBY]

Neu will install 8MM shaft and bearings for $85.00

[dasboata]

Congragulations to the guys that set records !! you all look like you had some fun, and thanks for posting all the great pics AND VIDS thanks for the mention Boyd, ,,,,,,,,,, Chris