Turnigy 180 cooling upgrade

[viper1]

Does the Tygon tubing give enough flexibility?

It does for me Steven, please define "enough" ?
Might be interesting to know that after I cut my hoses to length, I throw them in a bowl of very hot water. They gain some flexibility and seem to keep this even after cooling down. A better grip on the water nipples as well.

[Steven Vaccaro]

thanks for the info

[twissted]

I have these esc's running in my 42'' cat pushing 3674 2200kv. I have read that you can run them on 8s. I would like to try this. I have 1S-8S Lipo Battery Tester Low Voltage Checker Indicator LED Buzzer Alarm RC

$(KGrHqYOKpMFG6z)Qn85BR)7Vmu3Z!~~60_57.jpg I bought a pair of them.180 amp esc turnigy 007.JPG180 amp esc turnigy 008.JPG

I want to know what you think and this cooling that is done because of this? I have no cooling problems or problems at all on 6s. I use the Nano-Tec 65-130c liops.
What are your thoughts with the HK nano tech high discharge lipos?
Thank you.

[twissted]

Product Feature: 1-8SBB3.jpg
•
Use for 1-8s Lipl/Li-ion/LiMn/Li-Fe

•
Voltage detection pricision: 0.01V

•
Unit voltage display range: 0.5V-4.5V

•
Total voltage display range: 0.5V-36V

•
1S test mode voltage range: 4-15V
Low voltage alarm mode for 2-8S

•
Alarm set value range: OFF-2.7V-3.8V

•
When the voltage is below the set value,it will buzzer with red LED light,pre-set value 3.3V.

•
Push key

[larryrose11]

here is what I did to my T180 heat sink

The original, featuring broken water connectors!!


I milled most of the center out


finished part


assymbly


finished heat sink