King Of Shaves C1 Brushless!

[NitroVal]

No just single, but i'd imagine its not far off.

[6S HYDRO]

No it would be totally off.

[NitroVal]

How so?

[6S HYDRO]

Its double the thrust

[RCprince]

wondering if the Neu 1115:1.5D (3500kv) or the 1y(2800kv) or a 2d(2600kv) would be a good upgrade?

[NitroVal]

But it still would not affect top end. Even with twice the power, if both motors are spinning the same RPM and the same prop, the calculations should be similar. To test this theory, I finally was able to run mine today. With 4000mah 3S LiPos it did a top speed of 31.3mph in a light chop. I'll post videos when I get them edited.

[NitroVal]

I dont think any of the Neu's would work. These motors are 380 size and most of the Neu's are 540 or bigger. I just ordered new mounts from OSE and when I've had my fun with the box stock, I'll throw them in along with a pair of Castle 5700's I have lying around (for now) and run it on the 3S. Should be interesting..

[NitroVal]

Ok, heres an onboard ride with the EKOS I did today.. This boat handles like its on rails, except when you have a top heavy camera mounted on the deck, which is why the turns are a little slow. This was the first time it saw water, and I am very impressed. My only complaint (which may be driver error) is the steering servo seems pretty week. It had a hard time returning to center after a turn.

http://www.youtube.com/watch?v=tZntBmVcldM

[RCprince]

I dont think any of the Neu's would work. These motors are 380 size and most of the Neu's are 540 or bigger. I just ordered new mounts from OSE and when I've had my fun with the box stock, I'll throw them in along with a pair of Castle 5700's I have lying around (for now) and run it on the 3S. Should be interesting..

The 1100 neu's are 380 size 28mm x 65mm the 1115

[Brushless55]

I dont think any of the Neu's would work. These motors are 380 size and most of the Neu's are 540 or bigger. I just ordered new mounts from OSE and when I've had my fun with the box stock, I'll throw them in along with a pair of Castle 5700's I have lying around (for now) and run it on the 3S. Should be interesting..

You will let out the majic smoke!!

[NitroVal]

The 1100 neu's are 380 size 28mm x 65mm the 1115

Oh ok, thats good to know. I was going strictly off what I saw on OSE's motor page.

[Tunda]

I think you need to hold it wide open alittle longer and you should get more speed........

[Rumdog]

Sweet vid man! Seems faster than 31 mph. Was it wide open as Tunda says?

[NitroVal]

Yea, when I was measuring the speed, I didnt have the camera on and it was WOT. I was in a little cove, so I didnt have a whole lot of running room, but I think the boat had enough power to get up to full speed pretty quickly. There was a light chop, but the boat was staying glued to the water pretty well

[Brushless55]

I like the rear rooster shot!