Motor Mount

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • ron1950
    Fast Electric Addict!
    • Aug 2010
    • 3024

    #1

    Motor Mount

    changed over to 5.5's today in the old geigo......no problems till i start screwing the motor back in......seems one of the blind nuts is stripped and wont tighten.......now this is no problem from proboat its just used a bit......after a trip to ace hardware and no 3 mm blind nuts ....another trip to hobby town and had to switch to 4-40 but at least i am back in buisness......the wood motor moiunt platform does not come out easy and was a pain to re epoxy but got it done.....so another 15 min job that turns into a 2 hr job.....story of my life
    Last edited by ron1950; 06-16-2011, 09:48 PM.
    MY RETIREMENT PLAN?????.....POWERBALL
    74 vintage kirby clasic hydro, pursuit mono, mg, 47'' mono, popeye hydro...
  • wilsta67
    Senior Member
    • Feb 2011
    • 203

    #2
    Originally posted by ron1950
    changed over to 5.5's today in the old geigo......no problems till i start screwing the motor back in......seems one of the blind nuts is stripped and wont tighten.......now this is no problem from proboat its just used a bit......after a trip to ace hardware and no 3 mm blind nuts ....another trip to hobby town and had to switch to 4-40 but at least i am back in buisness......the wood motor moiunt platform does not come out easy and was a pain to re epoxy but got it done.....so another 15 min job that turns into a 2 hr job.....story of my life
    LOL i here you about
    15 min job that turns into a 2 hr job.

    Comment

    Working...