Tweet
41" kelvar/carbon catamaran twin drive artr set
[KCHTW1133ART] US $580.00 US $550.00
Click to enlarge
41" catamaran ARTR twin drive set. Boat hull made up kelver / carbon composite with epoxy.
Recommended for use of Li-Po batteries (not included).
Specification:
Length: 41" or 1050mm (excludes rudder and strut)
Width: 11 3/4" or 300mm
Motor: 2 unit x water cooled 2075KV 3674 brush-less in-runner with motor mount
Drive system: stainless steel collets, 3/16" flexi cable, brass tube, teflon lining, teflon washers, machine billet propeller, prop nut, drive dog (installed) Other accessories: antenna mount, water tubings, rudder, singer drive
Parts NOT included: Batteries (11.1V 2100-4500mah) and chargers, radio system, boat stand, electronic speed controllers (ESC), servos.
zondafgartr1.jpg zondafgartr3.jpg zondafgartr4.jpg 41catch6.jpg
The last picture is from the carbon fiber boat that cost the same. It shows the back end well so I added it.
I know that this is a lot like the fightercat hulls and I was wondering it the 447/3 props are the way to go with this boat. I plan on running 2 hobbyking 180 esc in 6s.
This is my secound boat now and the firts new boat as I built the first one from a used gas hull converted to brushless. I'm looking for speed and thought that this boat was a nice place to start.
[KCHTW1133ART] US $580.00 US $550.00
Click to enlarge
41" catamaran ARTR twin drive set. Boat hull made up kelver / carbon composite with epoxy.
Recommended for use of Li-Po batteries (not included).
Specification:
Length: 41" or 1050mm (excludes rudder and strut)
Width: 11 3/4" or 300mm
Motor: 2 unit x water cooled 2075KV 3674 brush-less in-runner with motor mount
Drive system: stainless steel collets, 3/16" flexi cable, brass tube, teflon lining, teflon washers, machine billet propeller, prop nut, drive dog (installed) Other accessories: antenna mount, water tubings, rudder, singer drive
Parts NOT included: Batteries (11.1V 2100-4500mah) and chargers, radio system, boat stand, electronic speed controllers (ESC), servos.
zondafgartr1.jpg zondafgartr3.jpg zondafgartr4.jpg 41catch6.jpg
The last picture is from the carbon fiber boat that cost the same. It shows the back end well so I added it.
I know that this is a lot like the fightercat hulls and I was wondering it the 447/3 props are the way to go with this boat. I plan on running 2 hobbyking 180 esc in 6s.
This is my secound boat now and the firts new boat as I built the first one from a used gas hull converted to brushless. I'm looking for speed and thought that this boat was a nice place to start.