Tweet
Anyone know of a source for a variety of these mounts that fit on the front of a 540 motor mount to hold the stuff tube in place? I need one with a coupler for a 5mm shaft to a 0.130 cable and the corresponding brass tube...
-
-
The coupler runs inside the 'cage' ? Never seen anything like that but would sure like to know myself. Looks pretty cool!Mini Cat Racing USA
www.minicatracingusa.com -
Here is a link you can try, they have all kinds of sizes, I know the Germans use this setup.
Ken
Comment
-
I got one from MHZ USA several years ago for my Twinstorm which I converted to a single 700SC. The coupler was 5mm motor to 4mm shaft. Call them & check it out. MHZ USA shows it on their site as a "pre-order".You can get a 5mm motor to
.130 here at OSE.
2008 NAMBA P-Mono & P-Offshore Nat'l 2-Lap Record Holder; '15 P-Cat, P-Ltd Cat 2-Lap
2009/2010 NAMBA P-Sport Hydro Nat'l 2-Lap Record Holder, '13 SCSTA P-Ltd Cat High Points
'11 NAMBA [P-Ltd] : Mono, Offshore, OPC, Sport Hydro; '06 LSO, '12,'13,'14 P Ltd Cat /MonoComment
-
Found what I was looking for at Toughracing. Will use it with a OSE grub screw coupler.Comment
-
The Graupner versions are also available from Allan at ASTEC.
All the best,
RayComment
Comment