5 inch T Bar and Oiler Can

[racerr73]

Hi,
Just wondering what size hole should be in the bottom (inside the 6mm thread) of a Oiler can secured onto a 5 inch T Bar. The one i have purchased has a .5mm hole in it and has no chance of allowing oil to go through it. Also what size hole should be drilled into the 5/16th stuffing tube to allow the oil through.

Thanks in advance
Trevor

[CDIIdp]

I also wandering the same size obstacle and fishing line Dubai

[racerr73]

So with over 60 views and no replies i take it no one uses this method of oiling for there flexshafts.
Trev

[RayR]

The hole size depends on the oil viscosity. For example, many use a 1/16 hole and Mercury lower unit lube (90 wt gear oil).

[racerr73]

Hi RayR,
Thank you for your reply, that gives me a good start.
Trev