Tweet
I need to adjust the pushrod on my Proboat Voracity 36 to dial the rudder in so that I don't need to trim it so much.
Does anyone know what size the set screw is to adjust this?
I was able to get it loose using a 1.5mm hex screwdriver, but after tightening it back up the 1.5mm hex just spins inside the set screw.
It's the set screw in the lower-right corner of this pic, on top of the brass piece on the servo arm. Does anyone know the size?
Pro-Boat-Voracity-Type-E-36-inch-Brushless-Deep-V-3.jpg
Are the Du-Bro E/z Connectors 2-56 any good? Will they fit the proboat pushrod?
http://www.offshoreelectrics.com/pro...hp?prod=dh-489
Thanks.
Does anyone know what size the set screw is to adjust this?
I was able to get it loose using a 1.5mm hex screwdriver, but after tightening it back up the 1.5mm hex just spins inside the set screw.
It's the set screw in the lower-right corner of this pic, on top of the brass piece on the servo arm. Does anyone know the size?
Pro-Boat-Voracity-Type-E-36-inch-Brushless-Deep-V-3.jpg
Are the Du-Bro E/z Connectors 2-56 any good? Will they fit the proboat pushrod?
http://www.offshoreelectrics.com/pro...hp?prod=dh-489
Thanks.