Tweet
I have purchased the Fiberglass 50" P1 boat hull rc boat from:
I should receive the hull in a few weeks and will post a build thread once I start.
I need advice on motors, Esc, prop and stingers/strut.
I have a spare Seaking 180amp Esc suitable for up to 6 cell and would quite like to use this if I went for a twin motor set up.
Not sure if to go for a single motor set up or twin motor set up?
Which motor or motors should I purchase for either set up?
Have no idea as to which Stinger or strut to use?
What drive shaft should I use?
I already appreciate that I need to seriously reinforce this hull.
Thanks for any help given in advance.
Cheers
C
I should receive the hull in a few weeks and will post a build thread once I start.
I need advice on motors, Esc, prop and stingers/strut.
I have a spare Seaking 180amp Esc suitable for up to 6 cell and would quite like to use this if I went for a twin motor set up.
Not sure if to go for a single motor set up or twin motor set up?
Which motor or motors should I purchase for either set up?
Have no idea as to which Stinger or strut to use?
What drive shaft should I use?
I already appreciate that I need to seriously reinforce this hull.
Thanks for any help given in advance.
Cheers
C