Tweet
All,
I have a question about a single drive Cheetah setup, as this is my first one.
Going to try to run this weekend!!
What is the optimum strut depth? Where is this depth measured from?
What about angle?
I blueprinted this hull, as had Tiequman. How does this strut angle interact with this blueprinting?
On balance point. It is usually quoted as 30% from the back of the ride pade, but it that from the front of the boat to the back of the ride pads?
ON a tuned up cheetah, can someone give me a measurement from the back of the ride pads, to the balance point?
Thanks a lot team,
Larry
I have a question about a single drive Cheetah setup, as this is my first one.
Going to try to run this weekend!!
What is the optimum strut depth? Where is this depth measured from?
What about angle?
I blueprinted this hull, as had Tiequman. How does this strut angle interact with this blueprinting?
On balance point. It is usually quoted as 30% from the back of the ride pade, but it that from the front of the boat to the back of the ride pads?
ON a tuned up cheetah, can someone give me a measurement from the back of the ride pads, to the balance point?
Thanks a lot team,
Larry