Tweet
Ok so I'm finishing up my build and I am using my turnigy 9x and an HK 3ch rx.
Got everything setup and programmed the t180 esc and decided to see if the fail safe works. set very low throttle and power down my tx. The motor stopped as it should so I powered the tx back up and it went WOT and scared the crap out of me. I have no idea why its doing that. Any one have any advise?
Jeremy
Got everything setup and programmed the t180 esc and decided to see if the fail safe works. set very low throttle and power down my tx. The motor stopped as it should so I powered the tx back up and it went WOT and scared the crap out of me. I have no idea why its doing that. Any one have any advise?
Jeremy