Delta Force Rudder ????

[MAMBA2200]

what kind of offset is best for this hull would a 4 inch be ok and where if anyone does make them can i find a flexshaft ready to go its a df26

[RaceMechaniX]

Look at the hyperformane strut plus rudder system. 3" is about right. No one that I know of makes a pre cut shaft due to the differences in motor mounting position and strut location.

[MAMBA2200]

ok thanks for the info

[monojeff]

What about rudder length?
I am working on putting together a 31" mono I have a 95mm laying around but I think this will be a bit to small??

[RaceMechaniX]

I set mine about between 1/2" to 1" below the lowest point on the prop.

[MAMBA2200]

i ordered all my stuff for mine got a 3" offset 5" rudder which i plan to cut got the motor trimtabs turnfins and using a revolt flexshaft .150 m545 prop and a 4074 motor with a 200a swordfish esc now i play the waiting game

[ray schrauwen]

My old DF26 that I wish I never sold:

[MAMBA2200]

Very nice hope mine turns out as nice

Sent from my DROID RAZR using Tapatalk 2

[785boats]

I run a 3" rudder with 3" offset on mine.

[MAMBA2200]

good looking rig 785boats

[785boats]

Thanks.
I'm proud to say that she took first place at the Australian Nationals for EA Restricted Mono this year. It was a first time demonstration event, but still, it's a nice trophy.

[MAMBA2200]

thats awesome you should be proud of that