wich motors for this setup (41" Zonda)

[dana]

Those square drive cables?

[Mecka1990]

ehm, no, on my spartan, 3/16 flex with 3/16 shaft in a 3/16 stinger, want to repair my spartan, ordered a new esc from steven right now :-)

[dana]

You have ALOT of questions about a boat you don't even have yet. Why don't you slow down and just wait to get the thing.

[dana]

3/16 gap

[Mecka1990]

thats another boat, hahahah, thats the spartan with the flex problem, i lost my last flex because i only let 3-4 mm to the stinger from the drive dog, i think when i get speed and the flex starts to roll around it gets smaller and so i lost it, no room for flexing or how it was said.

[Mecka1990]

what you mean with 3/16 gap? my english is not the best, and translater translate this: 3/16 gap (head->wall)

[Mecka1990]

a 3/16 gap is 3/16 of the widh from the flex? so about 4-6mm?

[dana]

Make gap same width as flex cable size ok?

[Mecka1990]

ok. thanks :-)

[dana]

-) youre welcome

[Mecka1990]

my setuo for my spartan:

1x Leopard 4082 1600kv 2Y.
1x seaking 180 amps wiht added capacitor banks (new version)
1x traxxas radio and receiver set with 2056 servo
1x prather s220

stinger drive
cnc billet trim tabs
speedmaster long rudder with double pickup
68mm turn fins
2x3s 8400mag serial

[Mecka1990]

i bet i nerve you already hahahaha

[keithbradley]

If a 3674 4 pole motor won't spin a 43mm prop, I would throw them in the trash, not another boat.