ETTI 220 ESC / Spectrum Programming Question

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • K.R.Joye
    Fast Electric Addict!
    • Feb 2010
    • 1045

    #1

    ETTI 220 ESC / Spectrum Programming Question

    Regarding programing my Etti 220 esc;
    I'm following the instructions regarding setting correct beep inputs but when I go to save (full brake forward) its not giving me 4 confirmation beeps. My Thorottle trim is set on 100%forward 0%reverse. Using a new Spectrum rx

    Appreciate any input please.....
    ~~~~~~~~`Mach 5 racing'~~~~~~~~~~~~
    ****2008/9 MMEU LSO, 2008 LSH CHAMP****
    ~~~~~~~70 MPH Club Member!~~~~~~~~~
  • TRUCKPULL
    Fast Electric Addict!
    • Apr 2007
    • 2971

    #2
    When programing your ESC.
    Set both your forward and reverse to 100%

    After programing you can turn your brake down.

    Larry
    Past NAMBA- P Mono -1 Mile Race Record holder
    Past NAMBA- P Sport -1 Mile Race Record holder
    Bump & Grind Racing Props -We Like Em Smooth & Wet

    Comment

    • meangenesracing
      Fast Electric Addict!
      • Jun 2012
      • 1158

      #3
      Originally posted by K.R.Joye
      Regarding programing my Etti 220 esc;
      I'm following the instructions regarding setting correct beep inputs but when I go to save (full brake forward) its not giving me 4 confirmation beeps. My Thorottle trim is set on 100%forward 0%reverse. Using a new Spectrum rx

      Appreciate any input please.....
      Ken, if your trying to set the cutoff or any of the other ones I believe you don't use reverse. you hold full throttle plug in power and when you get to say voltage cutoff mode let throttle go to neutral then when it gets to the right cutoff setting you want hold full throttle. what I did at first was hold full throttle plug in power and just let it go through all the beeps and tones to learn the sounds. concentration and quiet is the key. hope my not so great explanation helps

      Comment

      • meangenesracing
        Fast Electric Addict!
        • Jun 2012
        • 1158

        #4
        Originally posted by meangenesracing
        Ken, if your trying to set the cutoff or any of the other ones I believe you don't use reverse. you hold full throttle plug in power and when you get to say voltage cutoff mode let throttle go to neutral then when it gets to the right cutoff setting you want hold full throttle. what I did at first was hold full throttle plug in power and just let it go through all the beeps and tones to learn the sounds. concentration and quiet is the key. hope my not so great explanation helps
        by the way I have one in my 1/8 scale and it's my favorite boat , runs awsome

        Comment

        • K.R.Joye
          Fast Electric Addict!
          • Feb 2010
          • 1045

          #5
          I have 3 of these things all plug and play except for the outrunner its giving me fits setting up. I tried it with my 1st gen Spectrum on same 100F /00R throttle settings and gave me the store beeps, go figure... Thanks guys!
          ~~~~~~~~`Mach 5 racing'~~~~~~~~~~~~
          ****2008/9 MMEU LSO, 2008 LSH CHAMP****
          ~~~~~~~70 MPH Club Member!~~~~~~~~~

          Comment

          • ray schrauwen
            Fast Electric Addict!
            • Apr 2007
            • 9471

            #6
            Programming reminds me of Suppo.
            Nortavlag Bulc

            Comment

            Working...