DF pirate 35 build

[Luck as a Constant]

The Neu 1521 is plenty enough. A 1527 is complete overkill in that hull. The 1521 is a bit Larger than a 4082 Leopard and more efficient, I would put it right there with a 4092 Leo powerwise. The 1577kv would be great for 6s2p and I would get a 200a+ ESC.

Thanks for the reply.
Do you have experience with the sf esc?


Sent from my iPhone using Tapatalk

[Make-a-Wake]

Here's the 200a Swordy that powers my 39" mono, Castle 1717 6s2p....................bulletproof.............so far.

[Luck as a Constant]

thank you good sir!

[Luck as a Constant]

Boat and cf showed up today.
And it begins


Sent from my iPhone using Tapatalk

[tlandauer]

Boat and cf showed up today.
And it begins


Sent from my iPhone using Tapatalk

I will be watching this as well.

[Luck as a Constant]

I will be watching this as well.

Yesway




Sent from my iPhone using Tapatalk

[Luck as a Constant]

How do you guys feel about zpoxy?
I have it here... But not sure if it's great...
Lmk


Sent from my iPhone using Tapatalk

[Make-a-Wake]

I will be watching this as well.

I one-upped ya!!

[Make-a-Wake]

Ok.........what motor????????? 1521, 1717, 4082, 4092 etc...............???

[Luck as a Constant]

Lol
Still not sure but it will either be a 1521 or a 1717.
I have plenty to do before I need to decide, and there's at least 5 feet of snow in my front yard


Sent from my iPhone using Tapatalk

[Make-a-Wake]

In my opinion the 1717 will have a little more gusto than the 1521. Its got Neu's "blessing" and most likely Neu's quality control. Plus its a bit bigger 46 x 85mm to the 1521 at 40 x 84

[Luck as a Constant]

Yeah I see what you mean.
As far as power goes tho, which has more?



Sent from my iPhone using Tapatalk

[flraptor07]

On the Zpoxy thing, that's about all I use 5min. and 30min depending on what I'm doing. I've never had anything come apart that wasn't my fault and that was only one thing. If I'm doing motor mounts or something like that I mix either milled fiberglass or milled Carbon Fiber with it to make it thicker, stronger and to color it. IMO Good Stuff !!! Their Finishing Resin is good too!

[tlandauer]

How do you guys feel about zpoxy?
I have it here... But not sure if it's great...
Lmk


Sent from my iPhone using Tapatalk

I have used the 30 min. Z-Poxy extensively, good stuff. The only thing is that it is pretty sensitive with the mixing ratio, and I am always afraid to have incorrect 1:1 ratio that I pour enough to the mixing cup for a precise reading. In the end, I have wasted quite a lot. Some people use a tiny amount on a piece of card board to mix, haven't figured out that technique out yet... Also when they say 30 min. pot life, I often wish it is still longer.

[Luck as a Constant]

So I gotta work fast I guess lol


Sent from my iPhone using Tapatalk