Zonda gets a face lift.

[Tbauer]

Just can't gun it, it has to get rolling first or you will prop spin.......... With 2 blade 45-47 boat leaps out of water, not these baby, slow roll out of hole, once at a decent clip, nail it!!!

[olwarbirds]

Im planning on getting a CF Zonda after I get my GP400 done...I was really surprised that you felt the Leo's had NOT performed well for you..been running 3674, 4074, 4082 2000kv and 2200kv on 4-6S with great results...our pursuit and DF monos running 4074 and 4082 2200kv on 6S have been hitting 70 mph plus with 4 min plus runtimes and no probs....I was planning on using 2 4082 1800kv for my Zonda....DJ

[twissted]

http://www.youtube.com/watch?v=RahtEy18OGY music only
http://www.youtube.com/watch?v=zGQVuwzCXdU music only brushless losi 5ive

http://www.youtube.com/watch?v=ahg1KhY7gTM Music only Custom Zonda

There I fixed it

[Doby]

http://www.youtube.com/watch?v=Cn2aJ6c611o

Expecting a vid with some water/boats.....not pavement????

[tlandauer]

Expecting a vid with some water/boats.....not pavement????

here in So Cal rain fall has been low... could be the western US as well...

[ray schrauwen]

Jack has a couple vids from back in Sept. 2013 but, the braking dog is too annoying.

[twissted]

It is warm. I'm punching holes in the buy know, but no ice at all. Ice fishing is out this year.

[borgie]

what are your experiences with them escs?

[twissted]

The HK 180 esc are a great esc! I would push them or the sea king as they are the same. I do want to learn how to get them to run on 8s. I have read that it is possible.

[twissted]

the new 200 I haven't been able to buy. There not stocking them so there must be a problem with them.

[borgie]

oh okk, i was talking about the 200s

[olwarbirds]

From what I've read the T180 supposedly can handle 8S. I dont remember exactly what thread it was in though....according to the person who is doing this, all you have to do is disable the LV cutoff in the programming ..... I have NOT tried this and not sure if I want too...I've been using the Hobbywing/turnigy T180 with no probs on several hot 4 and 6S setups with no probs at all...I do really wish they would get busy on a higher amp that is as good... DJ

[ray schrauwen]

Whatever you do don't get sucked into the new Turnigy 200amp HV esc. You have to load extra firmware to run a 4 pole motor or any motor with more than 2 poles. Unless I see a video of one running skippidy doo, stay away from this esc!

[ray schrauwen]

So far it's a POS esc. Do not bother with it. If you do and make a video of your success, please share it.

the new 200 I have been able to buy. there not stocking them so there must be a problem with them.

[twissted]

I'm running the 180 esc currently and I have been really happy with them in my gutted Zonda. I run only 6s and it does a great job. I want to step up to 8s to run different motors. To fit in the the zonda.