60" Dumas "Miami vice" offshore boat

[Chris Harris]

Man that stinks, sorry to hear about that. If you can't find original
parts try this place http://www.sdp-si.com/
They have tons of different kinds of small gears.

Chris

[Make-a-Wake]

Thanks a bunch Chris, I looked there and they actually have a 16 tooth bevel gear in 3/16 bore................hmmm. I just have to figure out the stuff like 'mounting distance' and a few others things....................

[T.C.]

Tough break, the boat really looked good.
Aren't gears measured by pitch and number of teeth ?
I took one of mine apart and found a loose set screw, I will blue lock tite all the set screws then reassemble, before I run it .
T.C.
P1010013.jpg

[HYDROJERRY]

Sorry to hear that Makea wake,,, ok so tell me if im wright or not in the earlier shows there boat was the white on but didnt the other boat they had was black??

[Make-a-Wake]

Dont know Hydro, I never really watched it. T.C., my set screws were all tight, just the wobbliness of the shaft due to no bearing.

Here's the link to the gears, the whole 'store' has two items in it?

http://www.shop.ampsinternationalhobbies.com/gears-02.htm

[Chris Harris]

Yes the Chris Craft in the earlier shows was primarily white with some
blue stripes down the side, actually the boat in the video above.
The Well Craft had dark blue sides and a lighter blue on the deck.

Chris

[Make-a-Wake]

Well, i cant seem to find the right gears, and I bet the outdrive system, even with new gears, cant really handle big brushless power. I'm gonna throw this on and be done with it, it's a beefy 1/4" driveline. I like the dual rudders cuz the boat is so wide and when turning left an offset rudder would definately come out of the water almost completely..............i really wanted to run the scale outdrive, oh well.

[srislash]

Too bad about the drive M-A-W. That one should do it though.Do you think that boat will lean much?

[lenny]

That boat will look nice with that rudder and drive setup for sure,
It may be a little touchy in a tight turn at high speeds.
How long are the rudder brackets from transom to front of rudder blades ?

[srislash]

Just a shot in the dark and maybe too late but ,How bout these http://www.wd200-modellbau.de/?Antri...FDirektantrieb

[Make-a-Wake]

Nice looking drive there Lenny, thanks. I'm just gonna throw the dual Rudder system on. I have a 1/4 bore x 465 i think, I'll use that on 6s2p.