thanks for the tip Mark, I actually use small cable ties around all the fittings, it's was a good thing to see how well they hold up, the tap fitting I made I posted about earlier in this thread was a bit short so I extended it useing the tube off a pop rivet and attached cable ties to the joint, the pressure at this point is the strongest water flow and when trying the lines, at the point just b4 it blew off at, the silicon tube at the extention joint had expanded like a ballon so the little cable tie held up pretty well in my book.
Rumdog, Im a tad
due to a lot of people seem to swear by this technic, I thought it would help.
One more question, should I ditch the x445 and go streight to the x450 for my next run or will this be too bigger jump?
Rumdog, Im a tad

One more question, should I ditch the x445 and go streight to the x450 for my next run or will this be too bigger jump?
Comment