Tweet
Its been a slow process building this boat. I have built a bracket and mounted the 3 motors to it and attached to the boat. Also have a deck ready to be glassed in, just havnt had enough time in the past few months to do so since fishing season started. Ill post pictures of what i have done as soon as i can get them from my office.
Need some Wiring and Battery help.
What i have so far is 3 Turnigy marine 60A ESCs and 3 Turnigy B36-56-06 1800kv motors mounted in the outboards. The batteries will be mounted way up front and the ESCs somewhere in the middle. I need to extend the wiring to connect everything together. What kind and gauge wire should i use to connect everything?
Also what size batteries should i use to run each motor? I was thinking about a 4s in the 3000-4000mAh size but i dont know what C rating to get?
I need to make sure things done get to hot under the hatch.
Any help would be greatly appreciated.
Capt Jeff
Need some Wiring and Battery help.
What i have so far is 3 Turnigy marine 60A ESCs and 3 Turnigy B36-56-06 1800kv motors mounted in the outboards. The batteries will be mounted way up front and the ESCs somewhere in the middle. I need to extend the wiring to connect everything together. What kind and gauge wire should i use to connect everything?
Also what size batteries should i use to run each motor? I was thinking about a 4s in the 3000-4000mAh size but i dont know what C rating to get?
I need to make sure things done get to hot under the hatch.
Any help would be greatly appreciated.
Capt Jeff
Can't wait to see this come together.
Comment