View Full Version : Collet / Cable shield mod
LuckyDuc
04-30-2009, 03:10 PM
Considering that I have a plethora of wires (Eagle tree stuff) in my UL-1 I found a need for a collet shield “mod” to prevent the wires from becoming entangled in the spinning drive line. Unfortunately I didn’t come up with this idea before one of my Eagle Tree Temp sensor wires wrapped itself around the drive cable. Live and learn I guess. :doh:
Hopefully none of you will repeat my mistake. Here is a picture of my collet shield.
Jeff Wohlt
04-30-2009, 03:16 PM
That is a dandy idea! I like it more for the fact that grease does not get thrown around the hull from the cable!
LuckyDuc
04-30-2009, 06:02 PM
Thanks!
The grease catcher was an added benefit.:biggrin:
detox
04-30-2009, 06:08 PM
That piece also makes a nice water deflector.
I wonder if the Realtree system is robbing your UL-1 of MPH. All them Dean's connections add some resistance I am sure. Did you ever add bullets to your Ul-1?
...........
LuckyDuc
04-30-2009, 06:15 PM
That piece also makes a nice water deflector.
I wonder if the Realtree system is robbing your UL-1 of MPH. All them Dean's connections add some resistance I am sure. Did you ever add bullets to your Ul-1?
...........
I did last week. I put 5.5mm bullets everywhere but on the motor.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.