PDA

View Full Version : Rigger HYDRO1 ( NAVIGA)


wapniak
09-06-2015, 03:03 PM
It is my new rigger:

And short film: (prop 40x1.4)
https://www.youtube.com/watch?v=09Eb8vIr2cE

and first run on prop 38x1.4:
https://www.youtube.com/watch?v=CcjVoTDS1KY
high-tech
09-06-2015, 08:34 PM
Nice!!! I like it
NativePaul
09-08-2015, 02:43 AM
It looks good Wapniac, is that your own design? You have done very well to get it down to 970g, especially as it looks pretty big. Your testing is paying off, that second video looks a lot less bouncy than the first. Are you getting runtime yet and what is the motor and cells? I have to admit I am pretty lost with the extra minute runtime this year.
wapniak
09-08-2015, 01:20 PM
It looks good Wapniac, is that your own design? You have done very well to get it down to 970g, especially as it looks pretty big. Your testing is paying off, that second video looks a lot less bouncy than the first. Are you getting runtime yet and what is the motor and cells? I have to admit I am pretty lost with the extra minute runtime this year.


Yes, it is my design.
Size is 760x500 mm ( hull with prop) .
Motor Turnigy 2845, akus A-SPEC 4500mAh 3 cell, 280 g. Runtime is 400s.
In second video rear of hull has been changed.
NativePaul
09-08-2015, 01:36 PM
Very very good weight for the size then, it is even bigger than I thought. What did you do to the rear? less angle on the ski?
wapniak
09-08-2015, 02:48 PM
Yes, little less angle.
wapniak
09-13-2015, 07:21 AM
One more video after little changes:

https://youtu.be/vPXPKtAHdhQ