View Full Version : Swordfish 240HV procedure
T.S.Davis
07-12-2015, 01:41 PM
Okay, here I am again trying to make a SW fire. Not very optimistic but I'll ask again.
What is the procedure to arm/calibrate a Swordfish ESC?
wuzofoz
07-12-2015, 04:26 PM
i only have 220amp pro version. not sure if the same.
to calibrate hold at full throttle and power up esc. you will have a tune then 4 single beeps. during those 4 beeps return trigger to middle and you'll get last beeps.
to arm i just plug in and give a little blip on throttle after it beeps
hope this helps
wuz
T.S.Davis
07-12-2015, 05:30 PM
Thanks. I finally did figure it out. Tried it on a 120 too. Now just need to see if it works.
oscarel
07-12-2015, 07:20 PM
http://www.hifei.com/#!swordfish-esc/cidm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.