MGORMAN
06-11-2015, 11:05 AM
Hello Everyone,
I have a UL1 that I took the stock flex shaft out and replaced it with an upgraded one. If I remember right it's .150 flex. I guess my issue is that the Original strut bushing only goes about half way on up won't even slide back all the way to put into the strut.? I've read that some people sand them I've also bought the upgraded strut bushing which fits fine one the flex shaft At the back end. But the bushing don't go into the strut .?!?! Like real tight. Like outside diameter is too big to fit inside the strut on the boat. Hope I explained this well. It's very frustrating for something so easy..haha
Any info or tips are appreciated.
Mike
I have a UL1 that I took the stock flex shaft out and replaced it with an upgraded one. If I remember right it's .150 flex. I guess my issue is that the Original strut bushing only goes about half way on up won't even slide back all the way to put into the strut.? I've read that some people sand them I've also bought the upgraded strut bushing which fits fine one the flex shaft At the back end. But the bushing don't go into the strut .?!?! Like real tight. Like outside diameter is too big to fit inside the strut on the boat. Hope I explained this well. It's very frustrating for something so easy..haha
Any info or tips are appreciated.
Mike