flex shaft ques

[waynedawg]

what is the best way to cut a flex shaft? thanks:confused1:

[Mich. Maniac]

Dremel and cut-off wheel

[Apples1]

tape the end and dremel

[ChaKane]

Depends on how far down the flex you go. I would probably solder up the area of flex you are going to cut before doing so. This will make the shaft solid for cutting and also reduce any spurs and unravelling of the flex during cutting.

[Ub Hauled]

Dremel or equivalent for sure.

[waynedawg]

ok guys thanks for the info im new to boating and im modifiying my blackjack 26