waynedawg
09-02-2008, 10:25 PM
what is the best way to cut a flex shaft? thanks:confused1:
ChaKane
09-03-2008, 08:20 AM
Depends on how far down the flex you go. I would probably solder up the area of flex you are going to cut before doing so. This will make the shaft solid for cutting and also reduce any spurs and unravelling of the flex during cutting.
Ub Hauled
09-03-2008, 11:47 AM
Dremel or equivalent for sure.
waynedawg
09-04-2008, 03:37 PM
ok guys thanks for the info im new to boating and im modifiying my blackjack 26
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.