fusion_m8
09-04-2014, 10:35 PM
I recently purchased an OSE flex cable for my Lucas Oil. AFter installing the cable and pushing it into the motor collett as far as it can go in, I have a huge gap of around 14-15mm between the drive dog and strut bushing. There's also quite a bit of free play between the prop shaft and the strut bushing which I figure would either lead to premature bushing and shaft wear at best, and/or catastrophic failure due to severe vibrations because of the excess free play between shaft and bushing. Please advise me what is normal for Aquacraft as I have not seen this type of free play between the shaft and bushing in my ProBoat Miss Geico even after dozens of runs.
The OSE wbsite says that the Lucas Oil flex cable length is around 14.80inches tip-tip, but when I measured the flex cable sent to me, its around 15.5inches. I have contacted OSE via email and I'm waiting for their response.
120377120378120379
The OSE wbsite says that the Lucas Oil flex cable length is around 14.80inches tip-tip, but when I measured the flex cable sent to me, its around 15.5inches. I have contacted OSE via email and I'm waiting for their response.
120377120378120379