View Full Version : BJ29 Stock servo removal/replacement

09-02-2014, 09:59 AM
I need to replace the stock Dynamite servo in my BJ29. After I removed the little piece of ply holding it down, it seems stuck/glued down with something. Is it glued as well from the factory? How to pry that servo out of there without damaging the ply tray it sits on?

09-06-2014, 10:04 AM
The stock servo is glued in securely! I had to almost destroy the thin plywood tray and rip it apart to pry the servo loose... Ouch!

09-06-2014, 01:23 PM
I epoxied my boat and could not move it even with a decent amount of force. So I left it and epoxied around it.

Luck as a Constant
09-06-2014, 01:30 PM
Use a hair dryer and heat it up a bit. Should come out easier

Sent from my iPhone using Tapatalk