PDA

View Full Version : How to install stuffing tube liner



96motorhead
07-14-2014, 11:55 PM
My bj29 needs new liner and no matter what I do I cannot get the stupid liners in. So far i've ruined two by trying to get them in. I'm on my 3rd and I can't screw this one up because I need the boat all next week. So far i've tried putting grease and silicon spray on it with no success and I have also put it in the freezer and I still cannot get them in more than 1.5 inches. My old stuffing tube looks to have a little bit smaller of a diameter so I don't know what to do and yes i'm ordering the right part according to proboat.

srislash
07-15-2014, 12:32 AM
These are a PITA. I think some success has been had with stretching them(hold both ends and pull). Maybe do a search in the Geico area. I remember it a year or maybe year and half ago. I think the Proboats are metric tubes.

96motorhead
07-15-2014, 02:08 PM
I can't find any tutorial anywhere.

srislash
07-16-2014, 01:38 AM
Mmm. I don't recall where or what it was started as.

tlandauer
07-16-2014, 02:24 AM
I remember that as well, was a short disscussion since it worked and the guy thanked whoever replied. When you stretch, it will become thinner (dia. Wise), but you have to see if the end that is entering has also shrunk, if not, cut that off immediately after giving the liner a good stretch.

96motorhead
07-18-2014, 12:26 PM
I got it installed. I stretched by hand and got it in.

Spartanator
07-19-2014, 12:14 PM
I got it installed. I stretched by hand and got it in.

Glad ya got it!