de-pro
03-23-2014, 07:47 PM
I recently picked up a Swordfish 200 pro 8s ESC, this esc does not come with a built in BEC. I also picked up the program card to help me change the setup while in the field.
The diagram #2 in the manual shows using the Y cable to wire everything together. It looks like you actually have to use 2 sets of them although not quite clear in the attached picture from the manual.
Please let me know if I am getting it right:
Use one Y cable, connect the female ends to both male plugs coming out of the ESc.
Use the male end of the Y cable and connect to the female end of another Y cable.
Connect the second female end of the secondary Y cable to the male lead from the battery
Connect the male end of the secondary Y cable to the programmer.
Does this make sense or I am over complicating it :confused2:
Thanks for the assistance
113401
The diagram #2 in the manual shows using the Y cable to wire everything together. It looks like you actually have to use 2 sets of them although not quite clear in the attached picture from the manual.
Please let me know if I am getting it right:
Use one Y cable, connect the female ends to both male plugs coming out of the ESc.
Use the male end of the Y cable and connect to the female end of another Y cable.
Connect the second female end of the secondary Y cable to the male lead from the battery
Connect the male end of the secondary Y cable to the programmer.
Does this make sense or I am over complicating it :confused2:
Thanks for the assistance
113401