Ozzypatrol
01-29-2014, 07:34 AM
Hey folks,
Picked up an offset rudder from pro boat a couple of months ago. Just fitting it now, the steering arm from the servo is a bit long so I was just going to cut to size and re-bend to slot into the servo horn. On the other end of the arm were it connect to the rudder the issue is the water boot going into the hull. With the rudder all mounted up the black cap on the arm is hard up against the rubber. Anyone got suggestions.
Pic to come
Cheers,
BJ
Picked up an offset rudder from pro boat a couple of months ago. Just fitting it now, the steering arm from the servo is a bit long so I was just going to cut to size and re-bend to slot into the servo horn. On the other end of the arm were it connect to the rudder the issue is the water boot going into the hull. With the rudder all mounted up the black cap on the arm is hard up against the rubber. Anyone got suggestions.
Pic to come
Cheers,
BJ