Sharpening skeg

[TrimmedOut15]

When sharpening the skeg, what do you do with the bottom of it? Do you leave it square, sharpen to a point or round the bottom of the skeg?

Also how far back from the front of the skeg do you go when sharpening?

[Fluid]

Not sure what you mean by the "skeg". The MC does not have a skeg. It has a strut and a rudder. Most will round the bottom of the rudder, but leave the strut alone.



.

[TrimmedOut15]

I'm sorry, you are right, the rudder. So sharpen the front of the rudder and round the bottom? I am assuming sharpen with a file then sand paper? Thanks again, trying to get the most out of it stock, when I get bored then ill get a bigger motor Esc. The setup and fine tuning is fun for me, any other tips?