PDA

View Full Version : were to buy the water hose nipple to the rudder or new rudder?



waterproof
08-01-2013, 06:10 PM
Hi!

I have broken the screew nipple back of the rudder on the im31 v2 there the water flows, the "waterpicup screew nipple"
I couldnt find a Complete rudder With this screew mounted, its sold out. And i only need this little screw there the hose is mounted on the rudder, i have been in the rc shop in my town a few but no one have a screew that fits the treads to the rudder.

The Geico water nipple was a little to big and i fast broken when i trying to screw it on..

Let me know if someone know where i can order this small screw or maby the hole rudder if i must buy it Complete, i think its 3,5mm screew and Geico have m4?

BHChieftain
08-02-2013, 09:37 AM
Are you talking about where the water hose connects to the rudder?
If so, could you try reaming out the threads and use a piece of brass tubing?

I have a few boats that do not have threads on the rudder and I just use brass tubing...

Chief

waterproof
08-02-2013, 01:57 PM
103273

Yes this little screew that the hose gets water from the rudder :)

I couldt find it and most of the shops is sold out. I have use glue but the treads is gone, i dont know how long it will hold so i want a new screew to fix the problem.

Do you just buy a piece that fits the hole and just glue it?

waterproof
08-03-2013, 08:38 AM
I have ordered this part at 4mm http://www.modellers.com/Produkter/Forbrenningsmotorer/Tilbehør/Trykknipler/Trykknippel-90-graders-4mm-JTE5296-p0000006986.aspx
And this 3,5mm http://www.modellers.com/Produkter/Forbrenningsmotorer/Tilbehør/Trykknipler/Trykknippel-3-5mm-til-OS-potteNo7--22681957-p0000001032.aspx

The problem is that the hole in the middle is to small so i dont think the boat will get enough water..
Can someone find the right part that i could order? I will be thankfull :)

BHChieftain
08-03-2013, 11:27 AM
For the brass tube method, for my rudder I got lucky and found a diameter that just barely fit-- it was very close but slightly too big so I was able to sand the brass tube to make a perfect press fit. You could also epoxy it in.

Here's a link to the replacement rudder in case you can't get it to work.

http://www.horizonhobby.com/products/impulse-31-deep-v-bl-rtr-v2-PRB4250B#t4

Chief

waterproof
08-03-2013, 11:42 AM
I understand. Horrizon hobby is also sold out. All places it just stand backordered so i think the proboat dosent have make enough parts yet to the impulse